Aftermarket Radio Installation Kits - Car Audio Installation All shipping ONLY $5

 Car Radio / Stereo Installation Kits - We have the radio / stereo install kit that you need! Car Audio Radio Install Kits for most vehicles - Install your next radio / stereo

HomeView CartContact Us  
PAC - OEM Integration
PAC - C2A-GM24 Amplifier Interface for luxury BOSE Sound System
 PAC - C2A-GM24 Amplifier Interface for luxury BOSE® Sound  System
The C2A-GM24 allows you to add a 2 channel aftermarket amplifier for GM vehicles with Class II data bus. What makes the C2A-GM24 unique is that is takes the fixed level audio signal from the factory head unit before it gets to the Bose® amplifier and gives you a variable output. The C2A-GM24 outputs are digitally controlled by the headunit's volume knob. You get full range audio signal, not a Bose® specific equalized output, highpassed or lowpassed output.
2 channel RCA outputs with left and right level adjustments for matching aftermarket amplifier/speaker audio signal to factory speakers.
User selectable to fade out when adjusting factory radio to front or to rear. Or select to be non-fading output.
+12volt remote turn-on output.
Plug & Play, no hard wiring required.
The C2A-GM24 does not replace the factory amplifier. If the factory amplifier is removed or disconnected, the C2A-GM24 will not function.
Vehicle application: 2003-2004 Escalade (all), Trail Blazer LT, Trail Blazer LTZ, Envoy SLT, Sierra Denali, Yukon Denali, Hummer H2 (2003 only), 2005 Escalade (all), Sierra Denali, Yukon Denali
Note: 2004 Hummer H2 and 2005 Envoy and Trailblazer, this interface will not work! Use the AOEM-GM24 to add a 4 channel amplifier.
 Instructions
Price:
$105.99
PAC - C2R-GM24 GM Warning Chime & Radio Replacement Interface
 PAC - C2R-GM24 GM Warning Chime & Radio Replacement  Interface
For most 2001-2003 GM SUV's and trucks. Retains warning chimes when replacing factory radio in vehicles without OnStar®.
Retains all warning chimes including back-up chimes, memory seats, low fuel, door/hatch ajar and others.
Provides a +12volt accessory wire.
Retains RAP (Retained Accessory Power) when key is turned off. Radio stays on until the door is opened or for aproximately 10 minutes.
Supplied wire harness to connect aftermarket stereo to factory speakers.
Will work in vehicle that have the factory Bose® amplifier removed or bypassed. Custom wiring is required.
Buzzer is built into the interface.
If the Bose® amplifier is not used/bypassed, you can use the C2R-GM24 to retain the warning chimes.
Vehicles supported:
2000-2003 Cavalier, Impala, Monte Carlo and Trail Blazer-non-Bose®
2002-2003 Malibu
2002-2003 Envoy SLE-not SLT
2001-2003 Montana and Venture
2003 Avalanche, Express, Silverado, Suburban, Tahoe, Savana, Sierra-not Denali, Yukon SLT and Bravada
2004 Grand Prix GTP
Vehicles not supported with exception of note:
2003 Hummer H2, Cadillac Escalade and all Denali's 2002-2003 Envoy SLT
 Instructions
Price:
$100.99
PAC - OEM-2 Premium Factory Sound Interface
 PAC - OEM-2 Premium Factory Sound Interface
The OEM-2 is the one-piece solution for replacing the radio or adding an amplifier to any factory system. By isolating the system, providing a 4 channel signal level converter, an internal remote trigger and a common ground speaker conversion circuit, the OEM-2 is truly a multi-problem solution.
Adjusts up to 4 channels of signal input from 2 to 60 watts
The OEM-2 transformer isolates the input and output circuits, blocking DC noise and preventing snap, crackles and pops typical in other products.
Sealed potentiometers prevent circuit-induced distortion and signal drift.
Allows for conversion of floating ground head units to match common ground speakers systems.
Provides an internal trigger to turn on a 2 amp/12 volt power line with a 1second delay for an amplifier or power antenna.
Deliver linear frequency response /-0.5 dB from 20 to 20,000 Hz, for unparalleled sound quality.
 Instructions
Price:
$29.99
My Install Kit is a registered Trademark All Rights Reserved. My Install Kit cannot be responsible for errors published online. Some information published has been provided by manufacturer's and or corporations. My Install Kit tries to maintain accuracy. My Install Kit recognizes all manufacturer's trademarks and or trade names herein and disclaims any proprietary interest in their use. Copyright My Install Kit © 2005

Car Audio Aftermarket Radio / Stereo Installation Kits - Faceplates, Wire Harnesses, Antenna Adapters & PAC aftermarket car audio installation accessories! Car Audio Aftermarket Radio / Stereo Installation Kits for most vehicles Don't worry about wiring up that new radio / stereo, with a radio / stereo install kit everything is a snap!